You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
Home > GPS Tracking > Spark Nano GPS Tracker > Spark Nano Hardwire Adapter Installation Guide
Spark Nano Hardwire Adapter Installation Guide
print icon

1. Locate the USB port on the GPS Tracking Device

 

 

2. Plug the USB connector from the hardwire kit to the GPS device USB port

 

 

3. Connect the Plus (red) and Minus (black) wire to the corresponding Plus and Minus of the vehicle power source. Possible connection options are:

a. Vehicle battery – connect to wires that come directly from the battery 
b. Ignition – connect to either ignition or acc
c. Vehicle fuse – connect to wires coming out of the fuse, either always on or need to be switched 

 

4. Depending on where the connection to the power source is made, it is best to secure the entire set up under the dashboard or in the trunk, away from heat and not interfere with vehicle operation. 

 

 

 

Feedback
0 out of 0 found this helpful

scroll to top icon