You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
Home > Other Products > Vehicle Surveillance > Rear View Safety > Wireless Safety Camera System For Forklifts | 5" Dual Screen Display Manual (RVS-577FW)
Wireless Safety Camera System For Forklifts | 5" Dual Screen Display Manual (RVS-577FW)
print icon

Before drilling please check that no cable or wiring is on the other side of the wall. Please clamp all wires securely to reduce the possibility of them being damaged while the vehicle is in use. Keep all cables away from hot/moving parts and electrical noisy components.

 

We recommend doing a benchmark test before installation to ensure that all components are working properly.

Step 1: Choose the monitor and camera locations.

Step 2: Install all cables in the vehicle, when necessary a 0.8 (20mm) hole should be drilled for passing camera cable through vehicles walls. Install split grommets where applicable.

Step 3: Once all cables and wiring have been properly routed, perform a system function test by temporarily connecting the system.

 

 

Troubleshooting

Problem Possible Causes/Solutions
No picture and sound The power switch is set OFF. Check power connection/
source.
No signal Check the camera power supply. Pair the monitor and camera again.
Dark Picture Adjust brightness/contrast.
No Color Adjust hue.

 

 

Attached below is a copy of the Manual for this device. For technical support, please contact the manufacturer's dedicated support team at (800) 764-1028 or send an email to [email protected].

Feedback
0 out of 0 found this helpful

Attachments

RVS-577FW.pdf
scroll to top icon